Difference between revisions of "Terminal block connections, recommended practice"

Revision as of 16:48, 9 March 2022

The following recommendations apply to spring and screw cage terminal blocks (TBs).

Wire ferrules

Wire ferrules are recommended for both stranded and solid wire, to prevent contact loss due to oxidation and wire deformation. In the case of stranded wire, ferrules also prevent shorts caused by splayed or broken strands.

A ferrule will effectively increase the wire diameter. When selecting a ferrule, make sure it is not too large to fit into the TB.

• 

  Ferrule crimped onto a stranded conductor

• 

  Twin wire ferrule

Assembly

To terminate a wire with a ferrule, insert it into the ferrule and crimp the ferrule to make a solid wire end. A twin ferrule is recommended when two wires will be connected to the same TB terminal; insert both wires into the ferrule and crimp. Use the proper crimp tool, which will leave a textured surface that is readily gripped by the terminal. After crimping, insert the ferrule into the TB and tighten it in place.

Stranded wire

Stranded wire:

• Do not insert bare strands directly into the TB.
• Do not apply solder to the strands.
• Use a wire ferrule. Insert the strands into the ferrule and crimp to make a solid end. Insert the ferrule into the TB.
• Provide a strain relief if the wire will be flexed or subjected to pulling forces.

Solid wire

Solid wire:

• The use of a wire ferrule is optional.
• It may be acceptable to insert bare wire into the TB. This should be avoided if the wire is subjected to vibration or pulling forces, or if the wire would be significantly deformed by the compressive force of the TB jaws.
• Do not flex the wire after installation.

Strain relief

It is recommended to secure all wires with strain reliefs. This is especially important if the wires will be subjected to vibration or pulling forces.