Difference between revisions of "826 demo (VB.NET)"

Revision as of 09:41, 17 May 2017

To jump-start your model 826 project, we offer a comprehensive demo that provides a GUI for nearly every hardware resource on the board. A pre-built executable is included to allow you to immediately configure and exercise the board's I/O interfaces. All VB.NET source files are provided, including a reusable module (mid826.vb) that declares all functions, types, and constants for the 826 API.

Installation

To install the demo software, follow these steps:

1. If you haven't already done so, download and install the 826 SDK
2. Create a new folder for the demo
3. Download the demo
4. Unzip the demo into the new folder

You may now run the demo in either of the following ways:

• Run app-826-win-vb.exe
• Open the VisualStudio project (app-826-win-vb.sln) and run the demo in the VB.NET development environment

User guide

Each GUI control is associated with an API function as explained in the following sections. Please refer to the 826 technical manual for information about API functions and hardware architecture and operation, and to the 826 technical wiki for application examples.

When the demo program is started, all GUI controls are initialized to indicate the current board state. The board's state is not changed when the demo starts.

General tab

Hardware Versions

• Board - PWB revision letter
• FPGA - firmware version number

Software Versions

• API - middleware version number
• Driver - device driver version number

SafeMode

• Active - SAF bit (safemode state); see S826_SafeControlRead, S826_SafeControlWrite
• Write-Enable Data - SWE bit (safemode write enable); see S826_SafeWrenRead, S826_SafeWrenWrite
• Triggers | Dio47 - XSF bit (enable dio47 triggering); see S826_SafeControlRead, S826_SafeControlWrite
• Triggers | Watchdog - SEN bit (enable watchdog triggering; see S826_WatchdogConfigRead, S826_WatchdogConfigWrite

Virtual Outputs

• 0-5 - see S826_VirtualRead, S826_VirtualWrite

Watchdog

• Control | Enable - see S826_WatchdogEnableRead, S826_WatchdogEnableWrite
• Control | Kick - see S826_WatchdogKick
• Status | 0-2 - see S826_WatchdogStatusRead
• Configure | Enable Stage1 Output - NIE bit; see S826_WatchdogConfigRead, S826_WatchdogConfigWrite
• Configure | Enable Stage2 Output - OEN bit; see S826_WatchdogConfigRead, S826_WatchdogConfigWrite
• Configure | Pulse RST - PEN bit; see S826_WatchdogConfigRead, S826_WatchdogConfigWrite
• Interval - watchdog intervals; see S826_WatchdogConfigRead, S826_WatchdogConfigWrite