File list
This special page shows all uploaded files. When filtered by user, only files where that user uploaded the most recent version of the file are shown.
 Date |
Name | Thumbnail | Size | User | Description | Versions |
|---|---|---|---|---|---|---|
| 15:47, 29 March 2017 | 518 photo.jpg (file) |  | 246 KB | JL | (Reverted to version as of 17:48, 11 March 2016) | 3 |
| 07:31, 1 March 2017 | 826 3Phase pwm.png (file) |  | 32 KB | JL | (fixed dio/counter routability) | 3 |
| 16:42, 28 February 2017 | 826 quadrature gen.gif (file) |  | 16 KB | JL | (corrected dio/counter matching) | 2 |
| 09:49, 22 February 2017 | 826 estop.gif (file) |  | 7 KB | JL | (A robust way to connect a 24VDC emergency-stop contact to model 826.) | 1 |
| 12:06, 6 December 2016 | 2453controlOut.png (file) |  | 113 KB | JM | (2453 output control page taken using fw 1270) | 1 |
| 12:05, 6 December 2016 | 2453configOut.png (file) |  | 146 KB | JM | (2453 output config page created using fw 1270) | 1 |
| 11:29, 6 December 2016 | 2453AdminNet.jpg (file) |  | 175 KB | JM | (2453 network admin page from the manual) | 1 |
| 11:29, 6 December 2016 | 2453controlA.jpg (file) |  | 101 KB | JM | (2453 control stream A from the manual) | 1 |
| 11:28, 6 December 2016 | 2453configA.jpg (file) |  | 155 KB | JM | (2453 configure stream A from the manual) | 1 |
| 11:27, 6 December 2016 | 2453index.jpg (file) |  | 67 KB | JM | (2453 index.htm from the manual) | 1 |
| 10:31, 6 December 2016 | Index.jpg (file) |  | 67 KB | JM | (jpeg picture of 2453 index.htm page out of the manual) | 1 |
| 08:18, 9 November 2016 | 826 ttl encoder.gif (file) |  | 27 KB | JL | (Wiring diagram showing how to connect two TTL/CMOS-compatible single-ended incremental encoders to the 826 board using counter channels 0 and 1.) | 1 |
| 12:15, 4 November 2016 | 826 encoder FLT.png (file) |  | 13 KB | JL | (Using an 826 counter channel to monitor an incremental encoder's active-low FAULT output. The differential pair is swapped between line driver and receiver so that a disconnected or unpowered encoder will be recognized as a fault.) | 1 |
| 12:02, 1 September 2016 | SmartAD pinout.gif (file) |  | 39 KB | JL | (Connector pinout used by Sensoray Smart A/D boards (e.g., model 418, 419, 518, 618, 619). For each sensor channel x (in range 0:7), PHx/PLx supply excitation to a passive sensor (if needed) and SHx/SLx are the differential analog inputs. TREF and +12V ...) | 1 |
| 10:54, 4 August 2016 | Clock filter minimum.png (file) |  | 13 KB | JL | (826 counter timing diagram showing external clock filtering with zero filter delay (filter is disabled).) | 1 |
| 10:53, 4 August 2016 | Clock filter general.png (file) |  | 19 KB | JL | (826 counter timing diagram showing general case for external clock filtering.) | 1 |
| 10:51, 4 August 2016 | 826 counter timing.png (file) |  | 21 KB | JL | 2 | |
| 06:33, 9 June 2016 | 826 serial data capture.png (file) |  | 7 KB | JL | (Using an 826 counter channel to capture data from a serial data source. Each data edge causes a counter snapshot that contains a reason code and timestamp.) | 1 |
| 09:32, 26 May 2016 | 2410.jpg (file) |  | 81 KB | JL | (Model 2410 is a compact open-frame module that interfaces 48 general-purpose TTL/CMOS compatible digital input/output (DIO) signals to Ethernet.) | 1 |
| 09:51, 11 May 2016 | 826PwmWatchdog.gif (file) |  | 27 KB | JL | (show inverted DIO output; label DIO_out router) | 2 |
| 11:39, 21 March 2016 | 518 power.jpg (file) |  | 171 KB | JL | (Power supply test points on model 518.) | 1 |
| 15:56, 4 April 2014 | 2255 photo.jpg (file) |  | 68 KB | JL | (Model 2255) | 1 |
| 15:41, 4 April 2014 | 826 photo.jpg (file) |  | 1.81 MB | JL | (Sensoray model 826 board) | 1 |
| 15:31, 4 April 2014 | 2226 photo.jpg (file) |  | 190 KB | JL | (Sensoray Model 2226) | 1 |
| 15:09, 25 April 2013 | AdgGroundReference.gif (file) |  | 8 KB | JL | (cropped) | 2 |
 First page |
 Previous page |
 Next page |
 Last page |